Rhino RC ESC

Rhino Crawler 80A

This ESC preloaded AM32 custom firmware. Its optimized for crawler and makes your car run super smooth and quiet, but it is also suitable for a variety of 1/8 scale or smaller cars. A built-in adjustable four voltage BEC with a maximum current 10A to apply the high torque servo. In addition, the e-Switch that comes with it avoids failures caused by harsh environments.

All wires are pre-soldered.

Feature
AM32 custom firmware
Sinewave startup allows the motor smoothly at ultra-low speeds Variable drive frequency
Low voltage, throttle loss and stalled rotor protection
High-performance 32-bit MCU
E-switch with long life and waterproof

Specs
Product Num.: A3100
Battery: 2~8S Lipo
Current: 80A cont.
BEC: max 10A, output 5.2~8.2V adjustable by DIP switch
Waterproof: ESC not supported / e-switch supported
FAN: not include, solder pads for power is reserved
Connectors: not include
Wires: battery 14AWGx150mm, output 14AWGx150mm, signal 250mm and e-switch 120mm
Dimensions: 60x29x15mm (without wires)

Link for downloading drivers and AM32 config tool
http://rhinoesc.com/download/

Rhino Crawler 40A

This ESC preloaded AM32 custom firmware. It’s optimized for crawler and makes your car run super smooth and quiet, but it is also suitable for a variety of 1/10 scale or smaller cars. A built-in adjustable four voltage BEC with a maximum current 3A. In addition, the e-Switch that comes with it avoids failures caused by harsh environments.

All wires are pre-soldered.

Feature
AM32 custom firmware
Sinewave startup allows the motor smoothly at ultra-low speeds Variable drive frequency
Low voltage, throttle loss and stalled rotor protection
High-performance 32-bit MCU
E-switch with long life and waterproof

Specs
Product Num.: A3110
Battery: 2~4S Lipo
Current: 40A cont.
BEC: max 3A, output 5.2~8.2V adjustable by DIP switch
Waterproof: ESC not supported / e-switch supported
FAN: not supported
Connectors: not include
Wires: battery 16AWGx100mm, output 16AWGx100mm, signal 200mm and e-switch 120mm
Dimensions: 39x26x11mm (without wires)

USB-Link

Suitable for a variety of ESCs, such as AM32/BL32, etc., connect ESC to computer for configuration or upgrade firmware.
It is portable and easy to use, just connect the ESC signal plug, connect the USB Type-C cable to the computer and install the VCP driver.

Specs
Product Num.: EUL-01
Wires: not include
Dimensions: 25x13x11mm

Link for downloading drivers and AM32 config tool
http://rhinoesc.com/download/